Voltage indicators, ports and test points

Verify if voltage is present or not without open the enclosure door.

SafeSide voltage indicators offers a visual indication if voltage is present or not. The voltage indicator is normally connected to the load side of the disconnector and illuminates when hazardous voltage or stored energy is present in each phase. The voltage indicator is supplied from the load, there are no batteries that need to be replaced.

SafeSide voltage indicators are available for 4 wire and 5 wire systems and for DC. The unit is installed either in a 0,75”/M20 hole or in a 30,5mm hole. There are also versions with fibre optics for applications there higher voltages in the enclosure door are not allowed.

Safe-Test point is protected by a high impedance circuit (120kΩ) and is used together with a standard Cat III/IV multimeter. Installed in a 30,5mm hole and make it possible for maintenance personal to perform voltage testing without open the enclosure door.

ChekVolt is the latest addition, a combination of a voltage indicator and voltage test point, to be installed in a single 30,5mm hole. Bright LED offers a clear visual indication if voltage is present, the test point is protected by a high impedance circuit. ChekVolt can be used in circuits up to 1000VAC/DC, transparent cover is included, ingress protection IP660 with cover closed.

SafeSide voltage port are used together with a non-contact voltage detector to verify if voltage is present or not without open the enclosure door.

Grace VTS voltage test station consists of one SafeSide voltage indicator and one Safe-Test point installed in an interface connector panel with transparent cover. High ingress protection, IP65 with cover closed.